Lighting the burners
The index above the knobs will help you to nd the corresponding
burner. Press the knob by turning it anticlockwise and bring it to the
ignition position; keep the knob pressed for about 5 seconds so that
upon its release the ame remains alight (in case of unsuccessful
ignition repeat the operation).
Igniting the Triple ring burner “DUAL”
Identify the knob with the help of the index near the knobs. Press and
turn the knob to the MAXIMUM symbol for 5 seconds. Once the burner
is lit, by turning the knob anticlockwise it gets to its rst block that
corresponds to the middle one.
By applying a bit of force the rst block is exceeded and the outer
ring goes out leaving only the little central burner turned on called
AUXILIARY. To adjust the auxiliary burner on minimum, rotate the knob
anticlockwise until it stops. At this point, to relight the burner, rotate the
knob clockwise up to the desired value.
84
Burners
Boretti Maggiore Cookers / Installation / Use / Maintenance EN
To Next Page
Loading...
