Personnel:
n
W
arehouse worker
Protective equipment:
n
Occupational safety clothing, chemical
resistant
n
Safety shoes
n
Safety gloves, chemical-resistant
n
Safety goggles
Special tool:
n
Tools, general
— Read and follow the safety instructions detailed in
Ä
Chapter
2.12 “Safety instructions for maintenance and rectifying mal-
functions” on page 30.
— Always adhere to the following storage conditions for the
Börger machine:
— The storage room must be evenly ventilated and free of
dust and vibrations
— The relative humidity must be below 65% and the tempera-
ture between 15 °C and 25 °C (59 °F and 77 °F)
— Avoid exposure to direct heat sources (sunlight, heating)
1. Repair any damage to the external coating, galvanized com-
ponents and corrosion protection on bare metal parts caused
by external influences.
2. Protect the Börger machine from cold, particularly from frost,
as well as from moisture, contamination and mechanical influ-
ences. Close the inlet and outlet connections in particular
(flange, coupling etc.), plus any other openings to the interior
with covers impermeable to moisture.
3. Before commissioning / recommissioning at a later date,
remove all protective covers and anti-corrosion coatings.
If the device was stored for two years or more, or if the
storage conditions detailed above could not be met:
Transportation, Storage and Installation
BA-Classic FL_en-US, 03.05.2018 www.boerger.de / www.boerger.com 59
To Next Page
Loading...