Personnel:
n
Mechanics
n
Qualified electricians
n
Manufacturer
Protective equip-
ment:
n
Occupational safety clothing, chemical
resistant
n
Safety shoes
n
Safety gloves, chemical-resistant
n
Safety goggles
Special tool:
n
T
ools, general
— Read and follow the safety instructions detailed in
Ä
Chapter
2.12 “Safety instructions for maintenance and rectifying mal-
functions” on page 30.
— To the extent necessary, amply secure the surrounding area
when performing maintenance. Cordon off the working area
with a red and white safety chain and a warning sign.
— Remove the quick-release cover in accordance with
Ä
Chapter
6.3.2 “Opening and closing the quick-release cover”
on page 125.
1. Replace the lubricants before commissioning as described in
Ä
Chapter 6.2.2 “Lubricant fill level and changing the lubri-
cants” on page 116.
2. Check all O-rings that come into contact with the medium and
the mechanical seal and replace them if necessary as
described in
Ä
Chapter 6.3.4 “Replacing the mechanical seal
” on page 149
3. Observe the drive manufacturer
’s instructions for storing the
drive.
4. Observe the manufacturer
’s instructions for storing any
accessories.
NOTE!
Börger customer service
Börger GmbH recommends contacting Börger customer service
in these cases.
Transportation, Storage and Installation
BA-Classic FL_en-US, 03.05.2018www.boerger.de / www.boerger.com60
To Next Page
Loading...