10 en | Installation Extension board with 16-input 16-output
2024-01 | V02 |
Installation manual
Bosch Security Systems B.V.
4 Installation
4.1 Mounting the device on a mounting rail
The extension can be attached on a standard 35mm (1.377in.) mounting rail using a snap-
in mechanism. Attach the extension into the upper edge of the mounting rail [1], then push
down the device and snap it onto the rail by pushing it towards the back [2].
Figure4.1: Mounting the AMC2 device on a mounting rail
For information on how to install the device in an enclosure, refer to the separate
instruction manual of the enclosure AEC-AMC2-UL01 or AEC-AMC2-UL02. After installing the
device, keep the door of the enclosure closed.
To Next Page
Loading...
Need help?
General
