76 pt-BR | Day and night mode
AVENAR panel 8000 | AVENAR panel 2000 |
AVENAR keypad 8000
2023-08 | 8.0 | F.01U.378.877
Manual do utilizador
Bosch Sicherheitssysteme GmbH
1. The panel is in night mode: Select Mudar p/ Modo Dia to switch to day mode:
2. Confirm your selection with Mudar p/ Modo Dia.
The panel is switched to day mode.
To cancel the operation, select Cancelar.
If the panel is in day mode, select Mudar p/ Modo Noite to switch to night mode.
Switching via the status bar
The panel is in night mode. To switch it to day mode:
4 Press
or
4 Select Mudar p/ Modo Dia to confirm the request or Cancelar to cancel the operation.
The panel is in day mode. To switch it to night mode:
4 Press
4 Select Mudar p/ Modo Noite to confirm the selection or Cancelar to cancel the
operation.
18.2 Showing details
It is possible both in day and night mode to display a list of all logical zones on the panel that
are currently switched to day mode.
To display a list of all detector groups in day mode
1. In the start menu, select Mudar p/ Modo Dia or Mudar p/ Modo Noite, depending on
which mode the panel is currently in, or select the "day mode" or "night mode" icon on
the status bar.
2. Select Mostrar detalhes.
A list of all logical zones that are switched to day mode is displayed.
18.3 Changing the time for resetting to night mode
Cuidado!
After the system starts up following a power cut or battery failure, the default set back time
in FSP-5000-RPS is reset.
Aviso!
Depending on the configuration, the set back time can be changed. It is only possible to make
a change for the current day. It is only possible to make a change if a specified time has
already been set for the current day in the programming software.
The set back time can be changed in day or night mode.
To change the time for resetting in night mode:
4 On the status bar, select
or
or
In the start menu, select Mudar p/ Modo Dia.
To Next Page
Loading...
