Bosch GreenSource SM024 - Terminology; Acronyms; Terms

Terminology | 69Greensource CDi Series SM Model
8733819578 (2019/02)Greensource CDi Series SM Model
Subject to change without prior notice
TERMINOLOGY
Acronyms
AHJ — Authority Having Jurisdiction
ASC — Anti-Short Cycle
CFM — Cubic Feet per Minute
COP — Coefficient of Performance. The COP provides a
measure of performance for heat pumps that is
analogous to thermal efficiency for power cycles.
DAT — Discharge Air Temperature
DRT — Discharge Refrigerant Temperature
DWT — Domestic Water Temperature
ECM — Electronically Commutated Motor
EER — Energy Efficiency Ratio
EWT — Entering Water Temperature
FLA — Full Load Amps
FZC — Freeze Coax Temperature
GLHP — Ground Loop Heat Pump
HP — Heat Pump
HPC — Heat Pump Controller
HPS — High Pressure Switch
HRP — Heat Recovery Package
IOM — Installation, Operation, and Maintenance Manual
LED — Light Emitting Diode
LLWPC — Low-Loop Water Protection Control
LPS — Low Pressure Switch
LRA— Locked Rotor Amps
LWT — Leaving Water Temperature
NPA — Name Plate Amps
PCB — Printed Circuit Board
(R/A) — Return Air
RAT — Return Air Temperature
RLA — Running Load Amps
SSA — Smart Start Assist
SSID — Service Set Identifier
WDT — Watch Dog Timer
Wi-Fi — Wireless Network
WIM — Wireless Interface Module
Terms
Conditioned space — Space within a building provided
with heated or cooled air or both (or surfaces) and,
where required, with humidification or dehumidification
means to maintain conditions for an acceptable thermal
environment.
Decommissioning — Means the final shut-down and
removal from operation or usage of a product or piece
of equipment containing fluorinated greenhouse gases.
Discharge Pressure — Referring to the pressure leaving
compressor.
Reclamation — Means the reprocessing of a recovered
fluorinated greenhouse gas in order to match the
equivalent performance of a virgin substance, taking
into account its intended use.
Recovery — Referring to the collection and storage of
fluorinated-greenhouse gases from products (including
containers and equipment) during maintenance or
servicing or prior to the disposal of the products or
equipment.
Recycling — Referring to the reuse of a recovered
fluorinated-greenhouse gas following a basic cleaning
process.
Repair — Referring to the restoration of damaged or
leaking products or equipment that contain, or whose
functioning relies upon, fluorinated-greenhouse gases,
involving a part containing or designed to contain such
gases.
Suction Pressure — Referring to the pressure entering
compressor.