Inspecting and Storing the Equipment | 7Greensource CDi Series SM Model
8733819578 (2019/02)Greensource CDi Series SM Model
Subject to change without prior notice
INSPECTING AND STORING THE
EQUIPMENT
Moving and Storage
If the equipment is not needed for immediate
installation upon its arrival at the job site, it should
be left in its shipping carton and stored in a clean
and dry area. Units must only be stored or moved
in the normal upright position as indicated by the
“UP” arrows on each carton at all times.
Initial Inspection
Inspect the product carefully for any defects or
discrepancies.
Should you identify any issue, contact the Bosch
Wholesaler/Distributor from which you purchased
the unit.
Standard Package
Fig. 3 SM Series Water-to-Air Heat Pump
Fig. 4 Installation and Operation Manual (Note: Actual IOM may differ
from the above photo.)
Fig. 5 Corner Caps Package (HZ units only)
Fig. 6 Hanging Bracket kit (HZ units only)
Fig. 7 Field-Installed Swivel Fittings (VT units only)
NOTICE: Never lift or move units by filter
racks, external piping, or attached options/
accessories.
WARNING: Follow instructions for stacking
limit for transit as well as storage as per unit
packaging label.
To Next Page
Loading...
