H
L
M
If in doubt, look it up
78
Display
messages
"
Call diversion: Y
ou can decide if you want to be connected to the target of
the call diversion or if you want to end the call.
– connect: Press the “Enter” key.
– end call: Hang up the receiver
.
If you do not wish to be disturbed by calls, you can switch the ringing tone
of
f. Calls are then only indicated by a short beep and the illuminated LED.
The message appears in the idle display if a headset is connected and
switched on. T
o switch the headset of
f: Select the line.
(only TH
) This status message blinks in your display: An exchange line has
been assigned for your connection using a partner telephone. Y
ou can now
dial or a connection can be completed for you using the partner telephone.
Y
ou can protect your telephone from unauthorized users. Y
ou can also de
-
termine which functions are to remain available after the lock is activated
(lock levels must be enabled by your BOSCH TELECOM service represen-
tative).
If the symbol for “Message” appears in the idle display ( ), one or more
messages are waiting for you in the telephone system. Y
ou can call them
up at any time.
Diver.
-
Do not disturb
Headset present
Line assigned
Lock
Messages
To Next Page
Loading...
