Need help?Do you have a question about the Bosch NurseCall Main Unit and is the answer not in the manual?
General| Type | NurseCall Main Unit |
|---|---|
| Manufacturer | Bosch |
| Category | Telephone |
| Communication Protocol | DECT, IP |
| Number of DECT Handsets | Up to 20 |
| Number of IP Connections | Up to 10 |
| Protection Class | IP20 |
| Power Supply | AC 100-240V, 50/60Hz |
| Operating Temperature | 0°C to 40°C |
Essential guidelines for safe operation and installation to prevent injuries and damage.
Consequences of not following safety rules, including accidents and property damage.
Broad safety advice, including electrocution hazards and proper electrical connection.
Instructions for powering the unit by connecting it to the mains supply.
Guide for connecting multiple units using the RS-485 bus.
General information about the programming mode and available methods.
How to program the unit using its built-in keyboard and display.
Instructions for programming the unit using the dedicated NPS software.
Essential programming steps required upon initial setup or after a reset.
A table detailing default parameter values and their corresponding pages.
Setting the mode for indicating transmitter positions, with feature restrictions.
Configuring how transmitter information is displayed on the unit.
Steps to enter the parameter programming mode and navigate parameters.
A comprehensive list of programmable parameters and their references.
Procedure for setting the current date and time on the unit.
Configuring the RS-232 interface for different output types like PAGING or Alarm Management.
How to enable or disable local acknowledgement and set access codes.
Accessing and configuring special functions and codes.
How to reset all settings to factory defaults, necessary for certain changes.
Setting assistance and fire alarms as priority calls.
Setting assistance and fire alarms as non-priority calls.
Setting the unit as a "Universal NurseCall" system with auto-set parameters.
Procedures for programming and managing transmitters connected to the system.
How to enter the transmitter programming mode.
Step-by-step guide to program a new alarm transmitter.
Procedure to verify the settings and location of an alarm transmitter.
How to remove an alarm transmitter from the system.
Steps to program a new acknowledgement transmitter.
Procedure to verify the settings of an acknowledgement transmitter.
How to remove a single acknowledgement transmitter.
How to view stored alarms and events in the unit's buffers.
How to acknowledge alarms directly on the NurseCall Main Unit.
Guidance on checking the backup battery status and potential failure messages.
Detailed instructions and safety precautions for replacing the backup battery.
To Next Page
