24 en | Programming NurseCall Main Unit
F.01U.252.699 | V1.1 | 2012.01 User Manual Bosch Security Systems
4.2.2 Language
Select the unit language.
See Section 4.3.3 Programming the unit language, page 25 for more details.
4.2.3 Locating mode
Enable (ON) or disable (OFF) the indication of the transmitter position (locating mode) on the
NurseCall Main Unit display.
Press to disable or to enable the locating mode.
4.2.4 Display mode
Select the display mode for the transmitters’ identification.
1. Press to select NUMBER or to select FL,RO,BE (floor, room, bed).
2. If you select NUMBER, then you must choose between a 3-digit display (single number)
and an extended 4-sign display (digits and letters).
1. Press to select the 3-digit display 0-254 or to select the 4-sign display 0-ZZZZ.
¬ Language 0
English USA £
NOTICE!
It is mandatory to perform a reset if you wish to change the value for the locating mode.
See Section 4.4.2 Resetting all the parameters, page 34.
LOCATING ?
(OFF/ON )
WARNING!
When the locating mode is disabled, the accompany mode, tracking function and dementia
criterion are no longer available in the parameters programming.
NOTICE!
It is mandatory to perform a reset if you wish to change the value for the display mode.
See Section 4.4.2 Resetting all the parameters, page 34.
DISPLAY MODE ?
(NUMBER / FL,RO,BE)
NUMBERING RANGE
(0-254 / 0-ZZZZ)
To Next Page
Loading...
