Bosch NurseCall Main Unit - Checking Acknowledgement Transmitters; Erasing Single Acknowledgement Transmitter

NurseCall Main Unit Programming | en 41
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
 If the transmitter is not accepted, see Section 6 Troubleshooting and error messages,
page 46.
4.5.6 Checking an acknowledgement transmitter
1. Select the acknowledgement transmitter type with and .
2. Confirm with .
3. Press to check the transmitter.
4. Press the button of the transmitter.
XXXX is the ID code of the transmitter.
The unit then goes back to the acknowledgement transmitters menu.
4.5.7 Erasing an acknowledgment transmitter
1. Select the acknowledgement transmitter type with and .
2. Confirm with .
3. Press to select the erase function.
4. Press to erase ONE acknowledgement transmitter.
NOTICE!
To program the Free value to 5 or 32, see Section 4.4.10 Maximum number of acknowledgement
transmitters, page 37.
¯ Transmit. type : 1
Ack. Transmitter ¢
OK:Program
0:Erase ¤:Info
¯´ Press Radio
Button
Ack. Transmit.:1
Free:4 Code XXXX
¯ Transmit. type : 1
Ack. Transmitter ¢
OK:Program
0:Erase ¤:Info
¯ 'OK'= 1 Ack.Trans.
'*'= ALL !