NurseCall Main Unit Table of Contents | en 3
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
Table of Contents
1 Safety instructions 6
1.1 Importance of safety instructions 6
1.2 Disregarding safety rules 6
1.3 Environmental conditions 6
1.4 General safety instructions 6
1.4.1 Observation and information 7
2 Description 8
2.1 General description 8
2.1.1 Top view 8
2.1.2 Bottom view 9
2.1.3 Front view 10
2.1.4 Rear view 10
2.2 Detailed description 11
2.2.1 Loudspeaker 11
2.2.2 Display 11
2.2.3 Keyboard 11
2.2.4 RS-232 interface 13
2.2.5 RS-485 interface 14
2.2.6 Antenna 14
3 Installation 15
3.1 Unpacking 15
3.1.1 List of contents 15
3.2 Installation 16
3.2.1 Generalities 16
3.2.2 Installation on a piece of furniture 16
3.2.3 Wall installation 16
3.2.4 Installing the antenna 16
3.2.5 Connecting to the mains 17
3.2.6 Connecting the RS-232 17
3.2.7 Setting the jumpers on the communication board 18
3.2.8 Connecting the RS-485 19
3.2.9 Setting the 100 Ohm termination jumper 20
4Programming 21
4.1 Generalities 21
4.1.1 Programming with the keyboard 21
4.1.2 Programming with the NPS software 22
4.1.3 Exit the programming mode and cancel entries 22
4.1.4 Key not allowed 22
4.1.5 Locking and unlocking the keyboard 22
4.1.6 Programming time-out 22
4.2 First use 22
4.2.1 List of original factory settings 23
4.2.2 Language 24
To Next Page
Loading...
