NurseCall Main Unit Programming | en 31
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
4.3.6 Local acknowledgement setting
1. Select the parameter Nr. 03.
2. Press .
3. Activate (YES) or deactivate (NO) the acknowledgement at the NurseCall Main Unit.
4. Confirm with .
5. If you have selected YES, enter the access code. Press then .
6. Select YES if each acknowledgement must be done by entering the code 45 or NO if a
direct acknowledgement with the Green button shall be enabled. Confirm with .
4.3.7 Output relay setting
This parameter sets the relay as a "closing" or "switching" contact.
1. Select the parameter Nr. 04.
2. Press .
3. Select ON if you wish a "closing" relay or ON/OFF if you wish a "switching" relay.
4. Select the relay activation according to alarms. Choose between:
- Mode HELP & ASSIST
- Mode ASSISTANCE
- Mode FIRE
5. Confirm with .
¬ Parameter Nr. 03
Local Ack. ¡
¬ Local Ack.
Possible ? YES ¡
ACCESS CODE ··
¬ Local Ack.
Access Code ? YES ¡
¬ Parameter Nr. 04
Relay Output ¡
¬ Relay Output
Func: 'ON' ¡
¬ Relay Output
Mode HELP & ASSIST¡
To Next Page
Loading...
