NurseCall Main Unit Programming | en 39
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
The unit goes then back to the alarm transmitters menu.
4.5.3 Checking an alarm transmitter
1. Select the alarm transmitter type with and .
2. Confirm with .
3. Press to check the transmitter.
4. Press the button of the transmitter.
XXXX is the ID code of the transmitter.
The transmitter’s location is displayed. The following example is for a floor/room/bed display:
5. Press to see the room value.
6. Press to see the bed value.
7. Press to see the pager value.
8. Press . The unit then goes back to the alarm transmitters menu.
NOTICE!
To program the maximum number of alarm transmitters (300 or 500), see
Section 4.4.9 Maximum number of alarm transmitters, page 37 .
¯ Transmit. type : 0
Alarm Transmitter £
OK:Program
0:Erase ¤:Info
¯´ Press Radio
Button
¯ Transmitter code
XXXX accepted
¯ Floor
Value: 001
¯ Room
Value: 012
¯ Bed
Value: 1
¯ Pager
Value: 00
To Next Page
Loading...
