Bosch NurseCall Main Unit - Factory Settings List

NurseCall Main Unit Programming | en 23
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
4.2.1 List of original factory settings
* Locating and display modes are set at first use. To change their value, reset the unit.
Parameter Original Factory Setting Page
Language English USA 24
* Locating mode Off 24
* Display mode Floor/room/bed 24
Output RS-232 None 27
Forwarding of transmitter ID via the RS-232 interface Off 27
RPE 670 / i-page for paging systems No 28
Day / night mode No 28
Night start for paging or phone DECT systems 18h00 28
Night end for paging or phone DECT systems 06h00 28
ID paging for paging systems 2 28
ID NurseCall for paging systems 1 28
Beep codes allocated to each pager Help:7; Assi: 5; Ackn: 2 28
Number of digits for ESPA 4.4.4. 3 28
Mix Mode ESPA 4.4.4 / Alarm Management Software No 28
Digit for the POCSAG paging system address 4 30
First digit for DeTeWe paging system address 1 30
Local acknowledgement Yes 31
Access code for local acknowledgement No 31
Output relay function Closing 31
Output relay mode Help + Assistance 31
Accompany mode No 32
Lower limit for the accompany mode 231 32
Radio noise check Yes 32
Relay output in case of a radio noise event Off 32
Tracking function No 33
Dementia criterion No 33
Range of automatic dementia gates Standard 231-254 33
Assistance alarm from S35Q, S37Q and S37L transmitters Off 33
Assistance and fire priority No 35
Special texts in German No 35
Set to Universal NurseCall No 36
Conversion code for Universal NurseCall No 36
Last 300 ID codes blocked for Universal NurseCall No 36
Maximum number of alarm transmitters 500 37
Maximum number of acknowledgement transmitters 5 37
Maximum number of events buffered 100 37
Disabling the daily messages check Off 37
Repeat alarms timing to RS-232 output 3 minutes 37
Speaker volume Midrange 43