NurseCall Main Unit Programming | en 35
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
4.4.3 Assistance and fire priority
This command sets the assistance call and the fire alarm as priority calls.
This means that alarms of these types will be displayed first.
1. Type the code 123991. The unit plays a melody and a confirmation message is displayed.
4.4.4 Assistance and fire non priority
This command sets the assistance call and the fire alarm as non-priority calls. This means that
the last alarm is displayed, whatever its type. This is the default value.
1. Type the code 123992. The unit plays a melody and a confirmation message is displayed.
4.4.5 Special texts in German
This command sets special texts in German. The displayed criteria are:
– BAD/WC instead of TECHNIK
– HILFE-2 instead of NOTRUF2
1. Type the code 123007. The unit plays a melody and a confirmation message is displayed.
4.4.6 Standard texts in German
This command sets standard texts in German. This is the default value.
1. Type the code 123008. The unit plays a melody and a confirmation message is displayed.
4.4.7 Standard NurseCall selection
This command sets the NurseCall system as "Standard NurseCall". This is the default value.
1. Type the code 001998. The unit plays a melody and a confirmation message is displayed
ASSISTANCE & FIRE
PRIORITY
ASSISTANCE & FIRE
NONPRIORITY
MULTITONE TEXTE
BAD/WC + HILFE-2
STANDARDTEXTE
TECHNIK + NOTRUF2
CAUTION!
It is mandatory to perform a reset before changing this value.
See Section 4.4.2 Resetting all the parameters, page 34.
UNIVERSAL NC ? NO !
.............
To Next Page
Loading...
