NurseCall Main Unit Programming | en 25
Bosch Security Systems User Manual F.01U.252.699 | V1.1 | 2012.01
4.3 Parameters
4.3.1 Access to parameters
1. Press then to access the parameters.
2. Press to program these parameters or to check the value of each parameter.
3. Scroll with and . Press to confirm. Press to escape.
4.3.2 List of parameters
4.3.3 Programming the unit language
Choose between 7 language settings:
– 0 = English USA
– 1 = English UK
– 2 = French
–3 = German
– 4 = Italian
– 5 = Dutch
– 6 = Swedish
1. Select the parameter Nr. 00.
¬ OK:Program
¤:Info
¬ Parameter Nr. 00
Language £
No. Parameter Reference
00 Language Section 4.3.3 Programming the unit language, page 25
01 Date and time Section 4.3.4 Date and time setting, page 26
02 RS-232 output Section 4.3.5 RS-232 output setting, page 27
03 Local acknowledgement Section 4.3.6 Local acknowledgement setting, page 31
04 Relay Output Section 4.3.7 Output relay setting, page 31
05 Accompany mode Section 4.3.8 Accompany mode, page 32
06 Radio noise check Section 4.3.9 Radio noise check, page 32
07 Tracking function Section 4.3.10 Tracking function, page 33
08 Dementia criterion Section 4.3.11 Dementia criterion, page 33
09 Assistance alarm Section 4.3.12 Assistance alarm from S35Q, S37Q and S37L
transmitters, page 33
NOTICE!
This parameter is set at first use. Here you can change it.
See Section 4.2 First use, page 22.
¬ Parameter Nr. 00
Language £
To Next Page
Loading...
