Bosch KTS 340 - Description of Unit; Status LED; Battery Charge LED; Wlan Led

1 689 989 038 2008-08-15| Robert Bosch GmbH
Product description | KTS 340 | 21KTS 340 | 21 | 21 en
Description of unit3.5
The KTS 340 is a modular, portable, mobile control
unit diagnosis system. The KTS 340 features a compu-
ter unit with memory card and an 8.4 inch LCD touch
screen. The KTS 340 control unit diagnosis software is
pre-installed on the memory card at the factory.
Both a stylus for the LCD touch screen and a virtual
keypad are provided for operation.
The KTS 340 and the accessories are supplied in a pro-
tective case.
KTS 340
Powered b
y ESI tronic
ax. 28 Vm
459843-5K
1
8
7
6
5
4
3
2
KTS 340 Fig. 1:
1 Stylus holder
2 Stylus
3 On/Off button
4 Power supply unit connection
5 USB connection
6 WLAN LED (for future extension)
7 Battery charge LED
8 LCD touch screen
There is a risk of injury from glass splinters should !
the LCD glass cover break.
CH2
ax. 60 Vm
DIAG
CH1
K
459843-1K
Rear view of KTS 340Fig. 2:
1 Stylus compartment
2 CH2 measurement input
3 Ground connection
4 CH1(-) measurement input
5 CH1(+) measurement input
6 Connection for control unit diagnostic cable (DIAG)
7 Connection for Kensington lock
Status LED3.6
Battery charge LED3.6.1
Battery charge LED Status
Green light Battery fully charged, external
supply connected.
Flashing green Battery fully charged, external
supply not connected.
Yellow light Battery being charged, external
supply connected.
Flashing yellow Battery almost flat, connect exter-
nal power supply.
Red light Fault on charging.
Flashing red Battery flat (switch-off of KTS 340
within 2 minutes), connect exter-
nal power supply.
WLAN LED3.6.2
At present, the WLAN LED has no function; it is to be i
activated at a later date.
WLAN LED Status
Green light WLAN ready
Flashing green KTS 340 transmitting or receiving
data via WLAN.
Off WLAN not ready or malfunc-
tioning.