Bosch KTS 340 - KTS 340 Start-Up; 5 Operation; Connection to Vehicle

1 689 989 038 2008-08-15| Robert Bosch GmbH
Commissioning | KTS 340 | 25KTS 340 | 25 | 25 en
The KTS 340 is now licensed and can be used for control "
unit diagnosis.
Operation5.
Connection to vehicle5.1
The KTS 340 is designed for operation on vehicles with
a battery voltage of 12 V and 24 V.
Make sure the OBD diagnostic cable is properly con- !
nected to the KTS 340 and firmly attached. Incorrect
connection could cause the pins of the connector
to bend or break off. Only use the OBD diagnostic
cable contained in the scope of delivery.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
3
2
7
6
CH2
ax. 60 V
m
DIAG
K
CH1
KTS 34
0
Powered by ESI tr
onic
459843
8
5
4
KTS 340 connection diagramFig. 3:
1 OBD diagnostic socket in vehicle
2 OBD diagnostic cable
3 UNI connecting cable (special accessory)
4 USB connecting cable
5 Connecting cable for cigarette lighter socket
6 Power supply unit
7 KTS 340
8 Measurement cables
There is a risk of injury caused by triggering
of the airbag if the KTS 340 is placed on the
steering wheel.