Software update5.6
The software update is either performed using the
"ESI[tronic] Startcenter" DVD or "Online".
The online help for the software update can be i
found in the ESI[tronic] Startcenter software under
"Help >> Help".
Software update using ESI[tronic] DVD5.6.1
Insert the "1. ESI[tronic] Startcenter" DVD in the
DVD drive (e. g. "D:\") of the PC/Laptop.
Open the "2. Execute" input box (select "Start >>
Execute..." in the task bar).
Enter3. D:\setup.exe and confirm with <OK>.
Set-up is started. ?
Follow the installation instructions on the screen. ?
Re-start the computer on completion of installation. 4.
Windows is shut down and the ESI[tronic] Start- ?
center re-started.
Use the USB connecting cable to connect the 5.
KTS 340 to a PC/Laptop.
Use the power supply unit provided to supply the 6.
KTS 340 with voltage.
The KTS 340 starts up. ?
The USB link and the power supply to the KTS 340 !
must not be interrupted during the software update.
ESI[tronic] Startcenter: Open "7. KTS 340 >> Device
information".
Select available update.8.
Select <9. Update>.
The system software is installed on the KTS 340. "
Online software update (as of ESI[tronic] 5.6.2
Startcenter version 2009/2)
Start the "1. ESI[tronic] Startcenter".
Open the "2. Settings >> Online updates" input box.
Enter customer number and password and select 3.
<Continue>.
If " i Login" is not possible, check proxy settings under
"Settings >> User settings".
Select available update and start software update.4.
Follow the installation instructions on the screen.5.
Re-start the computer on completion of installation. 6.
Windows is shut down and the ESI[tronic] Start- ?
center re-started.
Use the USB connecting cable to connect the 7.
KTS 340 to a PC/Laptop.
Use the power supply unit provided to supply the 8.
KTS 340 with voltage.
The KTS 340 starts up. ?
The USB link and the power supply to the KTS 340 !
must not be interrupted during the software update.
ESI[tronic] Startcenter: Open "9. KTS 340 >> Device
information".
Select available update.10.
Select <11. Update>.
The system software is installed on the KTS 340. "
Faults5.7
No communication with the control unit
The fault message "No system found" appears during
control unit diagnosis.
Possible causes Possible remedies
Wrong cable
connected.
Check whether the correct
cable has been used.
Wrong pin selected in
pin selection menu.
Consult "Diagnostic socket"
to see which pin has to be
used.
If problems of a different nature occur, please i
contact the ESI[tronic] service hotline directly.
To Next Page
Loading...
