14 en | Introduction MIC IP ultra 7100i │ MIC IP starlight 7100i
2019-12 | 1.2 | Installation Manual Bosch Security Systems
2.3 Additional Tools
The following table lists additional tools (not supplied by Bosch) that may be required to
install a MIC camera or its accessories:
1 Phillips-head screwdriver to secure the ground lug of the camera
1 Adjustable wrench or socket set to secure the base of the camera to mounting accessories
For canting cameras:
1 Torque wrench with a 5 mm Hex bit to remove/install bolts in the yoke arms
For installing an optional SD card on MIC enhanced models (MIC-7504-Z12xR, MIC-7522-
Z30xR):
a T20 Torx bit
To Next Page
Loading...
