F 037 300 069 (2013.05.21)
12
3.3. SCOPE OF DELIVERY
Two variants are available for the CIMS Mk IV, a standard version and an ATEX zone 1 certified
version.
3.3.1. CIMS MK IV STANDARD VERSION
The CIMS Mk IV standard version is delivered with the 9-pin male connector chassis, see drawing
F 037 A00 002, Appendix A. It comes together with an adapter ring, required for mounting the
CIMS on the hydraulic cylinder (see Section 4.1) and a check valve which has to be installed on
the cylinder if no leak oil line is connected (see Section 4).
3.3.2. CIMS MK IV ATEX VERSION
The CIMS Mk IV ATEX version is delivered without connector or cable gland, see drawing F 037
A00 004, Appendix A. It comes together with an adapter ring, required for mounting the CIMS on
the hydraulic cylinder (see Section 4.1) and a check valve which has to be installed on the cylinder
if no leak oil line is connected (see Section 4).
CIMS Mk IV standard Adapter ring Check valve
CIMS Mk IV ATEX Adapter ring Check valve
To Next Page
Loading...
