F 037 300 069 (2013.05.21)
4
2. GENERAL INFORMATION
This document is intended as an aid to the installation, putting into operation and maintenance of
the CIMS Mk IV sensor supplied by Bosch Rexroth B.V.
Before starting to work with the CIMS Mk IV sensor, the relevant sections of this instruction manual
must be studied properly. The result of installation and maintenance depends primarily on training,
experience and good craftsmanship of the personnel performing the work.
Warning!
The mounting and removal of CIMS Mk IV sensors is specialized work that
can only be carried out properly by qualified and experienced personnel. In
the event of questions or doubts arising, always contact the Bosch Rexroth
service organization or your supplier.
Repairing the sensor is not permitted. A defect CIMS Mk IV has to be replaced by qualified and
experienced personal.
The statements, information and data published in this document are, to the best of our knowledge,
accurate, reliable and true. The publisher of this instruction manual accepts no liability for damage,
in any form whatsoever, arising as a result of incorrectly performed installation, putting into use,
maintenance or repair.
Since Bosch Rexroth has no control over the use into which others may put this product, Bosch
Rexroth does not guarantee that the same results as those described herein will be obtained. Each
user should test under his own conditions to determine the product’s suitability for his own
particular application.
CIMS Mk IV is mechanically and electrically compatible with CIMS Mk II / III, except that the
standard connector changed from a 6-pin connector to a 9-pin connector.
The content of this manual remains the property of Bosch Rexroth B.V., Boxtel, The Netherlands.
Reproduction or disclosure to third parties in any form, whatsoever, is not allowed without the
written consent of Bosch Rexroth B.V.
To Next Page
Loading...
