About this product 19/48
RE 30277-02-B/07.2016, HEDE 10-3X, Bosch Rexroth AG
P = system pressure
UMRL = Upper measuring range limit
Current output:
Within the measuring range of the device the output signal ranges
between 4 and 20 mA.
Moreover, the following is signaled:
• System pressure above measuring range: 20...20.5 mA
• Error signaling from 21.5 mA on.
• System pressure below measuring range: 4...3.8 mA
Voltage output:
Within the measuring range of the device the output signal ranges
between 0 and 10 V.
Moreover, the following is signaled:
• System pressure above measuring range: 10...10.3 V
• Error signaling from 11 V on.
5.2.3 IO-Link
General information
The pressure sensor is provided with an IO-Link communication
interface, which requires an IO-Link-capable module (IO-Link master)
for operation.
The IO-Link interface enables direct access to the process and
diagnostic data and provides the possibility of setting parameters of
the pressure sensor during operation.
In addition, communication is possible via a point-to-point connection
with a USB adapter cable.
You can nd the IODDs necessary for the conguration of the device,
detailed information about process data structure, diagnostic
information and parameter addresses as well as the required
information on the necessary IO-Link hardware and software at
www.boschrexroth.de/hede10-3x
To Next Page
Loading...
