Bosch Rexroth HEDE 10-3 Series - Configuring the Display (Optional)

30/48 Commissioning
Bosch Rexroth AG, HEDE 10-3X, RE 30277-02-B/07.2016
• Exiting a parameter without adopting the settings:
For unlocking:
▶ Press [▲] + [▼]
simultaneously.
Menu level 2 changes to
level 1 or
level 1 changes to display.
8.4 Conguringthedisplay(optional)
▶ Select [uni] and set the unit of measurement:
– [bAr]
– [PSI]
– [MPA]
The selectable units of measurement depend on the
respective unit.
▶ Select [diS] and set the update rate and orientation of
the display:
– [d1]: update of the measured values every 50 ms.
– [d2]: update of the measured values every 200 ms.
– [d3]: update of the measured values every 600 ms.
– [rd1], [rd2], [rd3]: display as for d1, d2, d3; rotated
by 180°.
– [OFF] = The display is switched o in the operating
mode. When one of the buttons is pressed,
the current measured value is displayed for 30
s. The LEDs remain active even if the display is
deactivated.
Even with unsteady pressure characteristics, [d1]
provides optimum readability; the corresponding
algorithms are stored!