Installation 21/48
RE 30277-02-B/07.2016, HEDE 10-3X, Bosch Rexroth AG
7 Installation
CAUTION
Pressure!
Risk of injury due to pressurized or improperly installed component.
▶ Before installing and removing the pressure sensor, make sure
that the system is depressurized.
▶ Check the process connection for compatibility.
▶ Observe recommended tightening torques.
▶ Insert the pressure sensor in a G¼ process connection.
▶ Tighten rmly. Recommended tightening torque:
Upper measuring range limit value
in bar
Tightening torque in Nm
100, 250, 400 bar 25...35 Nm
600 bar 30...50 Nm
Depending on lubrication, seal and pressure load!
The sensor housing can be rotated by 345° with regard
to the process connection. Do not rotate past the end
stop!
To Next Page
Loading...
