EasyManua.ls Logo

Bosch Rexroth IndraControl L45 - Interface Overview Details

Bosch Rexroth IndraControl L45
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Standard Meaning
DIN EN 60 529 Degrees of protection (including housings and installa‐
tion compartments)
UL 508 Industrial Control Equipment
Fig.4-4: Used standards
The IndraControl L45/L65/L85 as well as the additionally available
function modules and the Inline terminals correspond to the CE re‐
quirements!
Systems with the IndraControl L45/L65/L85 that are used in resi‐
dential areas (housing, business and commercial areas as well as
small-sized enterprises) require a single approval by an authority
or a testing agency. In Germany, such single approvals are issued
by the ”Regulierungsbehörde für Telekommunikation und Post
(RegTP)” (German Regulatory Authority for Telecommunications
and Posts).
UL/CSA Certified
The IndraControl L45/L65/L85 are certified acc. to
UL508 (Industrial Control Equipment) and
C22.2 no. 142-M1987 (CSA)
However,
there can be combinations or extension stages with limited or missing
certification. Thus, verify the certification by using the UL marking on the device.
To guarantee an UL/CSA-compliant operation, the following condi‐
tions have to be fulfilled:
Use only insulated copper wire suitable for at least 60/75 °C.
4.5 Compatibility Test
All
Rexroth controls and drives are developed and tested according to the latest
state-of-the-art of technology.
As it is impossible to follow the continuing development of all materials (e. g.
lubricants in machine tools) which may interact with our controls and drives, it
cannot be completely ruled out that any reactions with the materials used by
Bosch Rexroth might occur.
For this reason, before using the respective material a compatibility test has to
be carried out for new lubricants, cleaning agents etc. and our housings / our
housing materials.
4.6 Wear Parts
This section describes the wear parts as well as their service life. Wear parts
are not subject to any warranty.
Display
The service life of the display is limited. A progressive deterioration of the dis‐
play takes place after the service life was exceeded.
Manufacturer's data for the service life of the displays:
60.000 hours for 23 ± 5 ℃ and 60 ± 20% RH (relative air humidity).
Bosch Rexroth AG DOK-CONTRL-ICL45L65L85-PR01-EN-P
Rexroth IndraControl L45/L65/L85 Control
22/81
Technical Data

Table of Contents

Other manuals for Bosch Rexroth IndraControl L45

Related product manuals