Bosch Rexroth IndraControl L45 - Demounting the Inline Terminals

A B
C D
Fig.8-2: Latching a terminal
8.2.3 Demounting the Inline Terminals
Proceed as follows to remove a terminal (see fig. 8-3 "Removing a terminal" on
page 53):
● Remove the labeling field, if present (see A1 in figure A).
If any of the terminal is provided with more connectors than one, all
these connectors are to be removed from the terminal. The sections
below describe how to remove a 2-slot terminal.
Pry out the connector of the terminal to be removed by pressing on the rear
connector shaft latch (A2 in figure A).
● Remove the connector (figure B).
● Remove the adjacent connectors of the neighboring terminals (figure C).
This ensures that the feathers of the voltage jumpers and the keyway/
feather key connection are prevented from damage. Moreover, the termi‐
nal can be accessed more easily.
● Press on the release mechanism (D1 in figure D) and remove the terminal
perpendicularly to the top-hat rail (D2 in figure D). If you have failed to
loosen the connector of the neighboring terminal to the left, this connector
now comes loose to protect the feathers of the voltage jumper and the
keyway/feather key connection.
Bosch Rexroth AG DOK-CONTRL-ICL45L65L85-PR01-EN-P
Rexroth IndraControl L45/L65/L85 Control
52/81
Installation and Maintenance