Bosch Rexroth IndraControl L45 - Mounting the Control

6 Display and Operating Components
6.1
General Information
On its front, the IndraControl L45/L65/L85 is provided with the following display
and operating components: a single-line display with four operating keys as well
as a LED and a Reset button.
6.2 Display and Operating Keys
Display
The display is a LCD display comprising 8 digits (5 x 10 dot matrix).
Fig.6-1: Display with four operating keys
The keys below the display have the following functions:
Key
Menu navigation Input functions
<Esc> One level up Cancel input
<Down>
(down arrow)
One menu entry down Reduce parameter value
<Up>
(up arrow)
One menu entry up Increase parameter value
<Enter> One level down Confirm input
Fig.6-2: Functions of the operating keys
6.3 Reset Button and LED
The reset button and a red LED are arranged in the section below the display.
Fig.6-3: Reset button and stop LED
Reset button
Press the reset button (< 2 s) to reset the complete assembly and
force
a restart of the unit without the need to turn off the supply
voltages.
The reset button can only be actuated with a sharp tool (e. g. a tip of a pencil).
LED
The LED serves for diagnostics/status display.
The
states indicated by the LED depend on the firmware used and are included
in the description of the particular system.
DOK-CONTRL-ICL45L65L85-PR01-EN-P
Rexroth IndraControl L45/L65/L85 Control
Bosch Rexroth AG 29/81
Display and Operating Components