1-10 System Overview MPH-02, MPB-02, MPD-02
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
1.2 Drive Controllers
Overview
Design of the IndraDrive Controllers
An IndraDrive controller basically consists of two hardware components:
• power section
• control section
BASIC single-axis
limited
performance
and i
nterface
flexibility
BASIC double-axis
limited
performance
and i
nterface
flexibility
A
DVANCED single-axis
high
performance and interface
flexibility
IndraDrive C
IndraDrive M
power section
• compact or modular design
• scalable power
• uniform design
Compact
1 ... 110 kW
M
odular
1 ... 120 kW
DF000108v01_en.fh7
control section
• scalable performance
• scalable functionality
• safety technology
Fig. 1-2: Design and types of the IndraDrive controllers
The following are connected to the power section:
• power supply unit (DC bus voltage)
• 24 V control voltage
• motor
Note: Each of the two types of the control section is described in the
separate documentation; e.g. "IndraDrive Drive Controllers,
Power Sections, Project Planning Manual"
(DOK-INDRV*-HMS+HMD****-PR**-EN-P; part no. R911295014).
The control section is a separate part of the IndraDrive controller and is
plugged in the power section. The drive controller is supplied ex works
complete with control section. The control section may only be replaced
by a qualified service engineer.
Power Section
Control Section
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
