MPH-02, MPB-02, MPD-02 Drive Control 6-93
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
Braking resistor diagnoses:
• P-0-0844, Braking resistor load
• P-0-0833, Braking resistor threshold
Braking resistor warnings:
• E2820 Braking resistor overload prewarning
• E2802 HW control of braking resistor
• E2829 Not ready for power on
Braking resistor error messages:
• F2820 Braking resistor overload
• F2821 Error in control of braking resistor
• F2825 Switch-on threshold braking resistor too low
• F8838 Overcurrent external braking resistor
Power section warnings:
• E8028 Overcurrent in power section
• 8057 Device overload, current limit active
Power section error message:
• F8060 Overcurrent in power section
Reaction to signaled errors of other drives in the drive system:
• E8058 Drive system not ready for operation
Supply in this case signals:
• E2810 Drive system not ready for operation
Error message if supply has switched off in the case of error:
• F2086 Error supply module
Braking Resistor
Power Section Supply
Drive System
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
