Bosch Rexroth IndraDrive MPH-02 - Page 615

MPH-02, MPB-02, MPD-02 Handling, Diagnostic and Service Functions 10-33
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
The current drive status is displayed with highest priority.
1 F4002
number of the drive in the
bus system of the
master
communication
error message
8-digit display
1 E2025
1 C0901
1 C09
1 AF
warning
command error
command
operating status
increasing priority
Fig. 10-15: Priority of displays with examples
By simultaneously pressing the "Enter" and "Esc" buttons (for 8 s!) you
can call up extended displays; subsequently pressing the "Up" button
activates the command input.
1.Er.Anz1 F2002
standard display
press
"
Enter"
and "Esc"
buttons for
8 seconds
extended display
2.Comand
"Up" button
commands/settings
e.g.:
Fig. 10-16: Activating the extended display and the command input
By means of the extended displays it is possible to additionally call up the
contents of certain parameters:
• error memory
• diagnostic message memory
• operating hours counter control section
• operating hours counter power section
• type designation of the firmware active in the device
• safety technology code, if safety technology option available
Priorities of Display
Activating Extended Display and
Command Input
Extended Displays
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com