MPH-02, MPB-02, MPD-02 Handling, Diagnostic and Service Functions 10-35
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
Starting from the extended display it is possible to activate commands
and make settings:
• set the drive address (drive number in the bus system of the master
communication)
• set the length of the fiber optic cable
• activate the "analog mode" master communication
• C07_x load defaults procedure command (loading controller
parameters resp. base parameters)
• other commands like
• C2200 Backup working memory procedure command
• C2300 Load working memory command
• C2500 Copy IDN from optional memory to internal memory
• C2600 Copy IDN from internal memory to optional memory
• C2900 Firmware update from MMC
Command Inputs
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
