Bosch Rexroth IndraDrive MPH-02 - Page 661

MPH-02, MPB-02, MPD-02 Handling, Diagnostic and Service Functions 10-79
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
Parameterization and Diagnosis via a PLC
• parameters can be changed via PLC (e.g. adjustment of positioning
blocks)
• extended diagnostic possibilities for the PLC by taking over the error
code
PLC
drive
controller
n
drive
controller
n+1
drive
controller
n+2
drive
controller
n+3
RS485 bus
command communication
(e.g. parallel I/O or field
bus)
RS232/
RS485
converter
RS232/
RS485
converter
RS232/
RS485
converter
RS232/
RS485
converter
DF0022v1.fh7
Fig. 10-38: Parameterization and Diagnosis via a PLC
Parameterization and Diagnosis of Drive Groups by an
Operator Unit
• realizing a central visualization unit
PLC
drive
controller
n
drive
controller
n+1
drive
controller
n+2
drive
controller
n+3
RS485 bus
master communication
(e.g. parallel I/O or field
bus)
RS232/
RS485
converter
RS232/
RS485
converter
RS232/
RS485
converter
RS232/
RS485
converter
DF0023v1.fh7
central
operator unit
Fig. 10-39: Parameterization and diagnosis of drive groups by an operator unit
Connection System
See separate Project Planning Manual "Control Sections"
Advantages for Application
Advantages for Application
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com