Bosch Rexroth IndraDrive MPH-02 - Page 667

MPH-02, MPB-02, MPD-02 Handling, Diagnostic and Service Functions 10-85
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
Step 8
Close list, send end
character: "<" (CR)
Step 9
character received
Character sequence ":>" found in
receiver buffer?
Step 10
Delete request in receiver buffer. All
characters to 1st "CR" (inclusive).
Next character received
"#"?
Parameter list successfully written.
yes
no
no
B
FD5006B1.WMF
part 1/B (previous page)
Error occurred during
parameter access.
Error code: #xxxx
yes
Next character in receiver
buffer "#"?
A
More elements?
part 1/A (previous page)
no
Error occurred during
parameter access.
Error code: #xxxx
yes
no
yes
Contents of receiver buffer:
"<" (CR) ["#xxxx"(CR)]"E01:>"
Fig. 10-45: Write access to list parameters (part 2)
Note: It is important to complete the input with the "<" character
because only then the data are accepted in the drive.
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com