Bosch rexroth M1-16 Series - Page 17

RE 64025-B/2021-08-12, Bosch Rexroth AG
General instructions onproperty damage and product damage | Control blocks for mobile applications 17/54
NOTICE
Environmental pollution due toincorrect disposal!
Careless disposal ofthe control block and its assembled parts, the hydraulic
fluid and the packaging material can cause environmental pollution!
 Dispose of the control block, hydraulic fluid, and packaging in accordance with
the national regulations in your country.
 Dispose ofthehydraulic fluid inaccordance with theapplicable safety
datasheet ofthehydraulic fluid.
Danger due tochemical oraggressive environmental conditions!
Product can bedamaged! If the control block is exposed to chemical or corrosive
environmental conditions, such as sea water, fertilizer or road salt, it can result
in corrosion or, in extreme cases, a loss of function. Leaks may lead toaleakage
ofhydraulic fluid.
 Take appropriate measures to protect the control block from chemical or
corrosive environmental conditions.
Leakage orspilling ofhydraulic fluid!
Environmental pollution and contamination oftheground water!
 When filling and draining hydraulic fluid, always place adrip tray under the
control block.
 Use asuitable binding agent ifhydraulic fluid isspilled.
 Observe the parameters in the safety datasheetforthe hydraulic fluid and the
specifications provided by the machine/system manufacturer.
Danger due toheat development incomponents!
Adjacent products may be damaged! Due toaheat development incomponents
(e.g. solenoids), adjacent products may be damaged during assembly ifno
sufficient safety distance iscomplied with.
 When installing the control block, check the safety distances to nearby
products to ensure that they are not damaged.
The warranty exclusively applies tothe delivered configuration.
The warranty claim becomes void with
• Faulty installation, commissioning and operation,
• Improper use,
• Removal ofthe tamper-proof caps and seals (e.g.with pressure settings),
• Control ofthe settings atthe factory,
• Conversions and additional installations,
• Opening ofthe valve,
• Improper handling,
• Use ofnon-original spare parts by Rexroth.