Important directions on use
2.1 Important directions on use
2.1.1 Intended use
Prerequisites for proper and safe use of the motors are proper transport, appropriate storage, proper
assembly and connection, careful maintenance, operation and overhaul.
The motors have been exclusively designed for installation in industrial machinery. The motors have
been designed and manufactured in compliance with the directives and harmonized standards speci-
fied in the following.
EU Product standard
EN 60034-1:2010 + Cor.:2010 Rotating electrical machines - Part 1: Rating and
performance (IEC 60034-1:2010, modified)
Valid within EU
EU Directives
2014/35/EU Low voltage directive
EN Standards
EN IEC 60034-5:2020 Rotating electrical machines - Part 5: Degrees
of protection provided by the integral design of
rotating electrical machines (IP code) - Classifica-
tion (IEC 60034-5:2020)
The machine manufacturer must evaluate
the electric and mechanic safety as well
as environmental influences in the assem-
bled state of the machine according to
the Machine Directive 2006/42/EC and EN
60204-1:2018 Safety of machinery - Electrical
equipment of machines -Part 1: General require-
ments).
The electrical installation must comply with
the protection requirements of EMC Directive
2014/30/EU. The plant manufacturer is respon-
sible for appropriate installation (for example:
physical separation of signal and power cables,
using shielded cables, ...). The EMC instructions
of the converter manufacturer must be observed.
The machine may not be commissioned before
conformity with these directives has been con-
firmed.
The observance of and compliance with the
specifications of the operating instructions (DOK-
MOTOR*-MS2N*******-PRRS-**-P) are part of the
intended use.
2.1.2 Unintended use
Any use of MS2N motors outside of the speci-
fied fields of application or under operating con-
ditions and technical data other than those speci-
fied in this documentation is considered to be
unintended use.
Unless explicitly provided for this purpose, the
motors may not be used in explosion-hazardous
areas.
Direct operation on the three-phase network is
forbidden.
Safety instructions
To Next Page
Loading...
Need help?
General