Bosch Vivalytic - HIS;LIS Interface Configuration

© Bosch Healthcare Solutions GmbH 15Instructions for use
Menu
To configure or set up a new Ethernet connection:
Select configure network:
As network type select Ethernet 1.
Select DHCP enabled to support dynamic host configuration protocol from the network.
Select DHCP disabled to set the following components manually:
• Internet protocol address (IP address)
• Subnet mask
• Gateway
Follow the instructions displayed on the screen.
To configure or set up a new WLAN connection:
Select configure network:
As network type select WLAN. The following components have to be set manually:
• Service set identifier (SSID)
• Security protocol
• WLAN password
Select DHCP enabled to support dynamic host configuration protocol from the network.
Select DHCP disabled to set the following components manually:
Internet protocol address (IP address)
Subnet mask
Gateway
Follow the instructions displayed on the screen.
If necessary a proxy can be configured.
To view the current configuration, select show network configuration.
5.4 Configuration of order/result interface (HIS/LIS)
The analyser exchanges information with hospital and laboratory information systems (HIS/LIS), if connected.
Itreceives orders from the system and uploads results.
Log in as an administrator for access.
4
CONTINUE
enabled
In the menu, select settings, select network/interfaces, then select order/result interface.
To configure or set up a new order/result interface to HIS/LIS:
Select configure interface:
The following components have to be set manually:
• Inbox location
• Outbox location
• Username
• Password
Follow the instructions displayed on the screen.
To view the current configuration, select show interface configuration.
The network must be connected to set up an HIS/LIS configuration.