© Bosch Healthcare Solutions GmbH16 Instructions for use
Menu
5.5 Configuration of data export to USB or network drive
Log in as an administrator for access.
In the menu, select settings, select network/interfaces, then select export configuration.
To configure or set up a new USB location:
Select configure export:
As export location select USB and make sure a USB drive is inserted.
Follow the instructions displayed on the screen.
To configure or set up a new network location:
Select configure export:
As export location select network. The following components have to be set manually:
• Location
• Username
• Password
Follow the instructions displayed on the screen.
To view the current configuration, select show export configuration.
5.6 Printer configuration
Log in as an administrator for access.
In the menu, select settings then select printer configuration.
To configure an existing printer as standard printer:
Select configure printer:
A list of configured printers will be displayed.
To set a standard printer, mark it in the list
To remove a printer from the list, press delete.
To configure a new printer:
Press add printer and select the desired printer interface:
• USB
• Network
• Shared
A list of available printers for the selected interface will be displayed. Select the desired printer or URL.
Follow the instructions displayed on the screen.
To view the current configuration, select show printer configuration.
Printer must be selected and switched on.
To Next Page
Loading...
