EasyManua.ls Logo

Bosch WAL28PH7NL - Removing Transport Locks

Bosch WAL28PH7NL
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NL Set up and connect
WARNING
Risk of injury!
installation site To demand
on a wall no snakes
between wall and
device clamping
man.
When used on a plinth, the device can
tip over.
The device feet for commissioning
rack on a plinth absolutely with
the fixings
Page 31
from the manufacturer
settle.
PAY ATTENTION!
PAY ATTENTION!
Residual water can freeze. Freezing
residual water can damage the
appliance and frozen hoses can burst.
Do not place the appliance in frost
sensitive areas or outdoors.
The appliance may contain residual
water. If you tilt the appliance more
than 40°, residual water can leak out.
Carefully tilt the device.
installation site To demand
4.4 Removing transport locks
Plinth The device with
locking lips
Page 31
confirm.
The device is secured for transport
with transport locks at the rear of the
device.
Remark: Keep the screws of the
transport locks and the sleeves for
later transport
Page 57.
Floor with wooden
beams
Place the device
guess at a wa-
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
1. Pull the hoses out of the holders.
kitchen The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
14

Table of Contents

Related product manuals