EasyManua.ls Logo

Bosch WAL28PH7NL - The Ministry in Essence; Switching on the Appliance; Set Program; Adjust Program Settings

Bosch WAL28PH7NL
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NL The Ministry in essence
s Take the information regarding Safe-
ness
Page 4
and Avoid material
damage
Page 11
heed.
The power-on process takes a few
seconds.
a An audible bump test
executed.
Information from the manufacturer about
use and dosage can be found on the
packaging.
13.2 Set program
Remarks
1. Turn the program selector and set
it to the desired programme.
"Programs", Page 27
s with liquid detergents only
tend to use self-flowing liquid
detergents
s various liquid detergents
don't mix
s detergent and fabric softener not
to blend
s Not stored for too long and strongly in-
using thickened products.
s no solvent-based, corrosive
using the disinfectants, e.g.
bleach
s Use dyes in moderation
salt can affect stainless steel
s no decolorizing agent in the appliance
ready to use
s No vinegar in the dosing container
fill
Page 35
for the intelligent
dosing system
2. If necessary, adjust the program
settings
Page 32.
13.3 Adjust program settings
Required: A program is set.
"Set program", Page 32
Turn on the program settings
to suit.
"Keys", Page 24
Observe the information on the
subject of operating logic.
Remarks
s The program settings will be
not stored permanently for the
program.
s When you use the intelligent dosing
activates or deactivates the
system, the setting is saved.
d1e Operation in essence
3 The Operation in es-
sentie
dOe Operation in essence
note: Detailed instructions for use
can be found at www.bosch-
home.com or by scanning the QR
code on the title page of these
operating instructions.
13.4 Save program settings
You can save your individual
program settings as favourites.
13.1 Switch on device
Requirements
Required: The device is correctly set
up and connected.
"Set up and connect",
Page 13
s A program is set.
s The program settings are
amended.
Press for about 3 s.
Press .
Press to recall the stored
program.
32

Table of Contents

Related product manuals