Home Connect NL
1. Set the program to level 3. Remark: The connection is
automatically re-established when Wi-
Fi is re-enabled.
a The display shows APP reflected
to give.
2. Press .
16.6 Resetting the device's
network settings
a The device is connecting
with the Home Connect app.
1. At least 3 seconds on ken. Busy-
3. As soon as the appliance is in the Ho-
me Connect app is displayed,
follow the last steps in the Home
Connect app.
2. Set program to position 5.
a The display shows rES reflected
to give.
a When the display con again-
the device is connected to the
Home Connect app.
3. on to press.
a The display shows yes reflected
to give.
16.4 Activate WiFi on the device
4. on to press.
a The network settings are
set back.
a If the display end shows, are the
network settings reset.
Remark: The energy consumption
increases compared to the values
indicated in the consumption value
tables when Wi-Fi is activated.
16.7 Remote start
Release the appliance for remote start
via the Home Connect app.
1. Approx. 3 s press.
2. Set program to position 4.
a The display shows Con reflected
to give.
Activate remote start Notes
3. Press until the display on
displays.
s The remote start is due to
deactivated for security
reasons under the following
conditions:
– Open the appliance door.
– Press .
– Press .
– Turn off the device.
– After a power outage.
s The remote start is possible due to
for safety reasons will not be
activated under the following
conditions:
– The appliance door is open.
– The detergent drawer is not
fully closed.
a WiFi is activated.
16.5 Deactivate WiFi on the
device
1. At least 3 seconds on ken. Busy-
2. Set program to position 4.
a The display shows Con reflected
to give.
3. Press until the display oFF
displays.
a WiFi is deactivated.
39
To Next Page
Loading...
