de Troubleshooting
disturbance
"E: 30 / -80"
Cause and troubleshooting
▶
Remove impermissible extensions from the water
drainage hose. Connect device
Pump cover is not screwed in completely.
▶
Make sure that the pump cover is screwed into the
device as far as it will go. The handle of the pump
cover must be vertical.
"E: 36 / -25 / -26"
"E: 38 / -25 / -26"
The drain pump is blocked.
▶
→
"Cleaning the drain pump ", page 40
The drain pump is blocked.
▶
→
"Cleaning the drum ", page 38
if the error is displayed again,
▶
→
"Cleaning the drain pump ", page 40
The inlet opening of the rubber boot is blocked.
▶
→
"Clean the inlet opening in the rubber sleeve ",
page 42
Water pressure is low. No
fix possible.
The filter in the water inlet is blocked.
▶
Clean the sieve in the water inlet.
The tap is closed.
▶
Open the faucet.
The water inlet hose is kinked or trapped.
▶
Make sure that the water inlet hose is not kinked or
pinched.
"E: 35 / -10" There is water in the bottom pan.
▶
Turn off the faucet.
▶
Call customer service.
→
"Customer Service ", page 54
Device is leaking.
▶
Turn off the faucet.
▶
Call customer service.
→
"Customer Service ", page 54
Detergent dosage is too high.
▶
Immediate measure: Mix a tablespoon of fabric
softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
▶
For the next wash cycle with the same load, reduce
the amount of detergent.
44
To Next Page
Loading...
