Troubleshooting de
disturbance
shines.
Cause and troubleshooting
Temperature is too high.
▶
Wait until the temperature has dropped.
▶
→
"Abort program ", page 33
The water level is too high.
▶
Select a suitable program for expressing.
→
"Programs ", page 26
Laundry is jammed in the door.
1. Open the door again.
2. Remove jammed laundry.
3. Close the door.
4th To start the program, pressStart / reload
.
flashes. Door is not closed.
1. Close the door.
2. To start the program, pressStart / reload
.
All other error codes
of.
Malfunction
▶
Call customer service.
→
"Customer Service ", page 54
"E: 30 / -20" Solenoid valve defective.
▶
Call customer service.
→
"Customer Service ", page 54
Detergent dosage is too high.
▶
For the next wash cycle with the same load, reduce
the amount of detergent.
Filled in additional water.
▶
Do not add additional water to the device during
operation.
Device works
not.
Mains plug of the power cord is not plugged in.
▶
Connect the device to the mains.
The fuse in the fuse box has tripped.
▶
Check the fuse in the fuse box.
Power supply has failed.
▶
Check that the room lighting or other devices in
the room are working.
Program starts
not.
Start / reload was not pressed.
▶
Press Start / reload .
45
To Next Page
Loading...
