Bosch WAX32MX2 - Page 46

de Troubleshooting
disturbance Cause and troubleshooting
Program starts
not.
Door is not closed.
1. Close the door.
2. To start the program, pressStart / reload
.
Child lock is activated.
▶
→ "Deactivating childproof lock ", page 34
- Done in + is activated.
▶
Check if - Done in + is activated.
→ "Keys ", page 24
Laundry is jammed in the door.
1. Open the door again.
2. Remove jammed laundry.
3. Close the door.
4th To start the program, pressStart / reload
.
The door cannot be
opened.
is activated.
▶
Continue the program by pressing fling or
Pumping out choose and Start / reload
to press.
→ "Continuing the program at Rinse Hold ", page 34
Temperature is too high.
▶
Wait until the temperature has dropped.
▶
→ "Abort program ", page 33
The water level is too high.
▶
Select a suitable program for expressing.
→ "Programs ", page 26
Power failure.
▶
Open the door with the emergency release.
→ "Emergency release ", page 53
Detergent does not work
pumped out.
The drain pipe or water drainage hose is blocked.
▶
Clean the drain pipe and water drain hose.
The drain pipe or water drainage hose is kinked or
pinched.
▶
Make sure the drain pipe and water drain hose are
not kinked or pinched.
The drain pump is blocked.
▶
→ "Cleaning the drain pump ", page 40
46