de Troubleshooting
disturbance Cause and troubleshooting
Program duration change
changes during the
washing process.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
▶
No mistake - no action required.
Notice: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The foam control system switches on a rinse cycle if the
foam builds up too much.
▶
No mistake - no action required.
Water is not visible
in the drum
bar.
Water is below the visible range.
▶
No mistake - no action required.
▶
Do not add additional water to the device during
operation.
Drum jerks
Program start.
The cause is an internal motor test.
▶
No mistake - no action required.
In the chamber
there is residual water
ser.
loading The insert in the chamber is blocked.
▶
→
"Cleaning the detergent drawer ", page 39
Vibrations and movement
the appliance during
spinning.
Device is not aligned correctly.
▶
Align the device
The feet of the device are not fixed.
▶
Fix the device feet. Align the device
Transport locks are not removed.
▶
Remove the transport locks
Drum turns,
Water does not run in.
Load detection is active.
▶
No mistake, no action required.
Notice: The load detection can take up to 2 minutes.
Strong foaming
manure.
Detergent dosage is too high.
▶
Immediate measure: Mix a tablespoon of fabric
softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
▶
For the next wash cycle with the same load, reduce
the amount of detergent.
High spin speed
number is not
reached.
The low spin speed is set.
▶
Set a higher spin speed for the next wash cycle.
48
To Next Page
Loading...
