Bose S1 PRO+ - Change between MIC and Line Input; Connect Effects to a Channel Insert When Using a Wireless Transmitter

WIRELESS TRANSMITTER CONTROLS
40
|
ENG
CHANGE BETWEEN MIC AND LINE INPUT
With the Bose Wireless Mic/Line Transmitter, you can change between mic and line
input settings to match the input requirements of your source.
To do so, press and hold the Power button I and MUTE button until the transmitter
icon on the channel display changes to reflect the new input setting.
MUTE
VOLUME VOLUME
LINE
LINE
Mic input Line input
CONNECT EFFECTS TO A CHANNEL INSERT WHEN
USING A WIRELESS TRANSMITTER
When you connect a wireless transmitter to a channel which has the Insert setting
set to Auto (see page 41), the l (6.35 mm) TRS channel input becomes a series
channel insert (also known as an eects loop). You can connect eects units or pedals
to the input using an insert cable, all while using your instrument or mic wirelessly.
For sample setup scenario images, see page 47.
NOTES:
• An insert cable (l or 6.35 mm TRS to dual l or 6.35 mm TS) is required to
connect an eects unit to a channel insert. You can purchase an insert cable at your
local music retailer.
• Don’t connect an instrument or other audio source to the input using a standard
l (6.35 mm) cable when a wireless transmitter is connected to the channel. This
prevents audio from playing from both the wired and wireless source.