TROUBLESHOOTING
73
|
ENG
Wireless transmitter
SYMPTOM SOLUTION
Wireless transmitter
doesn’t power on
Fully charge the transmitter (see page 55). Power on again.
Reset the transmitter (see page 77). Power on again.
Wireless transmitter
doesn’t charge
System battery may be in protection mode or discharged.
Connect the system to AC (mains) power.
If the transmitter has been exposed to high or low temperatures,
let it return to room temperature and then try charging again.
Charge the transmitter using a wall charger or computer
(see page 55).
If you’re using the system at a very high volume level, try turning
the volume down. At very high volume levels, the system pauses
charging the system battery and any connected
wireless transmitters.
Wireless transmitter
doesn’t connect
to system
Check the power light to make sure the transmitter is powered on
(see page 62).
Check the connection light to confirm whether the transmitter is
connected to the system or not (see page 63). If the light is
turned o, try pairing the transmitter to the channel again
(see page 37).
Move the transmitter closer to the system (within 20 ft or 6 m)
and away from any interference or obstructions.
Make sure that the Wireless setting for that channel is set to
Auto, not O (see page 42).
Reset the transmitter (see page 77). Pair the transmitter to the
channel again (see page 37).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
