12 / 30
8. You can continue programming or exit. To exit “Program” mode,
tap “Exit” button while holding down the “Record” button, the
“Record” LED should go out.
Example: Program a 32 steps chase with channels 1-32 at full in sequence into “Flash” button,
the “Record” LED should go out.
1. Record enable.
2. Push „Master A&B” to maximum position and fade to top.
3. Tap the „Mode Select” button to select „1-48 Single“mode.
4. Push channel fader 1 to the top position, its Led light at full intensity.
5. Tap the „Record” button to program this step into memory.
6. Repeat steps 4 and 5 until you’ve programmed channel fader 1-32.
7. Tap the „Page” button causing „Page 1” LED lights.
8. Tap the „Flash” button 15 while holding down the „Record” button, all LEDs will
flash indicating you’ve programmed the chase into memory.
To Next Page
Loading...