26 / 30
6. Brief of main functions
6.1. Reverse the direction of the scene
1. Reverse the direction of all scenes:
Press the „ALL REV” button, all the scenes should change their directions.
2. Reverse the chasing direction of all programs with speed control.
Press the “Chase Rev” button.
3. Reverse the chasing direction of all programs with standard beat:
Press the “Beat Rev” button.
4. Reverse chasing direction of any program.
‘Press and hold down the “Rec One” button, then press down the “Flash” button corresponding to your
desired program and release together.
6.2. Fade Time
1. The amount of time it will take for the dimmer to go from zero output to maximum output, and
reverse.
2. Fade time is adjusted through the “Fade Time” fader, which varies from instant to 10 minutes.
6.3. „Tap Sync“button
1. The „Tap Sync“button is used to set and synchronize the chase rate (the rate at which all scenes
will sequence) by tapping the several times. The chase rate will synchronize to the time of the last to
taps. The LED above will flash at the new chase rate. The chase rate may be set anytime whether or
not a program is running.
2. “Tap Sync” will override any pervious setting of the speed fader control until the fader is moved
again.
3. Use of „Tap Sync „in setting a standard beat it’s the same with speed control fader.
6.4. Master fader
Master fader control provides proportional level control over all channels and scenes with the
exception of the „flash“buttons. For example:
Whenever the master fader control is at minimum all stage outputs will be set at zero except for any
resulting from a „Flash“ button or „Full On“ button.
If the master is at 50%, all outputs will be only at 50% of the setting of current channel or scenes
except for any resulting from a “Flash” button or “Full On” button.
If the master is at full all outputs will follow the unit setting.
Master A always controls outputs of channel. Master B controls the program or scene except in
“Double Preset” mode.
To Next Page
Loading...
Need help?
General